ST-VP1 | VOICE-OVER / PAGING MODULE - MANUAL
Item # ST-VP1
VOICE-OVER / PAGING MODULE - MANUAL
Click image to enlarge
The ST-VP1 is intended for voice-over paging with user adjusted and controlled FADE or CUT between two input sources. This unit is also perfect for voice-overs where precise and consistent fade levels are required. Automatic operation can be achieved when used in conjuction with RDL´s ST-ACR products.
Features:
- High-Quality Voice-Over Mixing
- Noiseless Paging
- Single Input Adapted for Paging or Voice-Over
- Selectable Fade-Under or Hard-Cut
- Adjustable Fade DEPTH and RATE
- Soft Audio Switching
| Inputs (2) | Balanced line level (or unbalanced) |
|---|---|
| Input Impedance | 20 kΩ |
| Input Signal Range | -20 dBu to +18 dBu |
| Output | +4 dBu balanced (nominal) |
| Gain | Adjustable using multiturn potentiometer |
| THD+N | < 0.01% (20 Hz to 20 kHz, no compression) |
| Frequency Response | 20 Hz to 20 kHz (± 1 dB) |
| Noise | < -70 dB |
| Indicators (2) | 1 LED indicating proper music level 1 LED indicating proper voice level |
| AGC/Compressor | 18 dB range 6 dB compression at normal input level |
| Attack Time | 25 ms |
| Release Time | 2.5 seconds |
| Voice Trigger Level | 24 dB below operating level |
| Music Fade Depth | Adjustable 0 dB to −25 dB, or off |
| Music Recovery Delay | Adjustable 2 seconds to 4 seconds |
| Ambient Operating Environment | 0° C to 55° C |
| Power Requirement | GROUND-REFERENCED, 24 Vdc @ 35 mA |
| Package Type | Cardboard Box |
| Tariff code | 8543.70.9860 |
| WEEE weight | 0.145 lbs. |
| Shipping Weight | 0.2 lbs. |
| Package Dimensions | 2 x 2 x 4 in. |
Downloads
×
This website uses cookies to ensure you get the best user experience. By continuing to use this site, you agree to our cookies and terms of use policy.